Tag: wood-working

A couple months in the past, I was likely on and on about that Watertown all wood desk slide and how I may possibly uncover a way to re-intent it for my most important woodworking bench as a tail vise or a entrance vise, as element of the vise, known as the “manual rails”.

So when it comes to wooden and woodworking, “I know a man”. He has equally an amazing doing the job knowledge of all the a variety of items and solutions linked with managing a relatives owned, generational, at that, wooden shop. He definitely knows his things and is an excellent craftsmen, or additional precisely stated, He is a nicely seasoned expert “sawist or sawsman”. So lots of new phrases and so couple of mind cells remaining. 🙂

I advised him about my interest in executing this venture and inquired about receiving a personalized wood screw built and the linked connector components and his response was not to react at all ! , And permit his silence do the talking! So I was kind of taken aback by that and then recognized, I was lacking crucial dimensional particulars and so without that at the prepared, he experienced no authentic way to try to recognize just what I was right after. And to be truthful, I hadn’t done my research, so the professor had no magical answers up his sleeve for me.

So I scrapped the total idea and just went on line and bought a 10.5 inch huge, 20 inch deep, primary forged iron and stainless metal beneath bench-mount components package and had to just make my individual face board jaws and manage for it. So I obtained it all mounted up in excess of the earlier couple of times and experienced to engineer out a way to have the bench’s device tray act as the rear jaw of the vise and not get crushed in the procedure. But I imagine I obtained that accomplished properly and was capable to crush a tomato juice can, as an opening check of the vise’s health and fitness and of my underneath-mount occupation of deflecting or shunting the crushing force this vise can exert, which is borderline frightening! but great at the similar time! I’m this kind of a 3 year old! lol

For now, I produced use of a 1 inch thick slab of Butternut hardwood. This is touted as currently being “the white walnut” wooden but its a fair little bit lighter in its bodyweight and density and might conclusion up becoming the weaker hyperlink towards it can be walnut challenger at the other end of the screw.

The workable opening is just a shade about 12 inches, which is possible way extra then I’ll at any time want. The width of the front and back again lumber is 18 inches. You can find also a best to bottom plate peak of 3 inches at the rear and 6 inches on the front. But all of that can be transformed by injecting a thinner assembly line at the prime of the boards via rubber strip, etcetera.

I think I can now go back again to the drawing board on those people antique desk slides. 🙂

Cheers! 🙂

Posted by jeffpeletz@startmail.com on 2020-10-24 22:59:16

Tagged: , Wooden doing work , Do-it-yourself , bench vise , tail vise , weighty obligation , butternut wooden , walnut , oak , desktop , 4k , wallpaper

#furnishings #Do it yourself #woodwork #woodworking #freedownload#woodworkingprojects #woodsmith ,wooden craft, wooden planer, good woodworking, wood chairs, wood doing the job equipment, preferred woodworking, woodworking books, woodworking workbench plans