The author of this content is describing their experience with designing and building a project box enclosure for two printed circuit boards (PCBs). The author is using the top metal plate of the enclosure to label wire exit points. They note that they may consider using heat shrink encasing instead of zip ties for future tie-downs to improve aesthetics, but this may pose problems with maintenance or fixing in case of future stick breaks. The author is also considering routing ground wires to a separate terminal strip for maximum modularity in the electronics, meaning that if a wire fails, only that wire needs to be replaced rather than an entire splice section of the stick.
Overall, the author’s focus appears to be on optimizing the design and functionality of the project box enclosure. They are paying close attention to aesthetics and ease of maintenance, while also trying to create maximum modularity in the electronics. By using separate terminal strips for ground wires, the author is reducing the risk of needing to replace multiple parts of the stick in case of a failure, which could potentially save time and money in the long run. Ultimately, the author’s approach to building this project box enclosure appears to be both practical and thoughtful, with a focus on improving the overall value and performance of the stick.
Posted by BRThompsonator on 2009-04-06 05:53:08
