Tag: rock maple

We harvest basketball courts from universities. Apparently just about every 20-50 a long time universities swap 10s of 1000’s of sq. ft of gymnasium flooring and generally throw it away. Admittedly it is a little bit of a suffering to reuse in household options (but absolutely rather if the hard work is put in) and sizeable quantities of this materials have been made use of to make counters and tables desks and bar tops. For these prospects they required a fitness center floor table and we uncovered a scarce piece that nonetheless experienced its graphics. We discovered a pair of outdated 1950s conference desk legs and developed a table close to the piece…including having the graphics wrap all-around on the skirt.

The flooring is rock maple nailed into sleepers (basically 2×3 ). I stapled 3/4 in plywood strips to the base prior to taking away the sleepers. Immediately after the sleepers have been taken off I set some lower profile stiffeners built of more parts of strip maple turned sideways. The apron was also created from additional parts of maple. In this circumstance I utilised the items with the graphics to make the waterfall impact. Since the maple is tongue and groove I have to piece alongside one another parts on the groove side due to the fact they’d normally be backward. The corners had been produced with a mortise and tenon joint. THe apron is brad nailed into the ground and blocks glued and stapled underneath all around the edges,
The legs from the old meeting table have been sanded primed and repainted with shiny white enamel paint. The best and sides are sanded with 220 grit paper and coated with satin, h2o-dependent polyurethane. Treatment is taken to not take away the patina and where ever cuts and sanding exposed new wooden..time and sun will ultimately even it out.

Posted by ianulimac on 2021-01-10 02:18:24

Tagged: , Reuse Motion , reuseaction.com , reuse , reclaim , upcycle , recycle , rock maple , ground , basketball court docket , strip flooring , desk , conversion , maple , woodwork , craft , shop , woodshop , mortise , tenon , custom made , handmade , genuine , Buffalo , NY

#household furniture #Diy #woodwork #woodworking #freedownload#woodworkingprojects #woodsmith ,wood craft, wooden planer, great woodworking, picket chairs, wooden doing the job equipment, well-known woodworking, woodworking books, woodworking workbench designs

We harvest basketball courts from educational facilities. Evidently each individual 20-50 a long time educational institutions replace 10s of thousands of square feet of gymnasium flooring and usually toss it absent. Admittedly it is a bit of a pain to reuse in residential settings (but definitely quite if the effort and hard work is place in) and significant amounts of this substance have been employed to make counters and tables desks and bar tops. For these clients they required a health and fitness center flooring desk and we found a exceptional piece that continue to had its graphics. We located a pair of outdated 1950s convention desk legs and developed a table all around the piece…which includes getting the graphics wrap all-around on the skirt.

The flooring is rock maple nailed into sleepers (effectively 2×3 ). I stapled 3/4 in plywood strips to the base prior to eliminating the sleepers. Soon after the sleepers were eradicated I set some low profile stiffeners built of additional items of strip maple turned sideways. The apron was also built from more pieces of maple. In this circumstance I utilised the pieces with the graphics to build the waterfall outcome. Since the maple is tongue and groove I have to piece jointly parts on the groove aspect mainly because they’d normally be backward. The corners were being manufactured with a mortise and tenon joint. THe apron is brad nailed into the ground and blocks glued and stapled beneath all around the edges,
The legs from the previous meeting desk were being sanded primed and repainted with shiny white enamel paint. The leading and sides are sanded with 220 grit paper and coated with satin, water-based polyurethane. Treatment is taken to not get rid of the patina and wherever cuts and sanding uncovered new wooden..time and solar will eventually even it out.

Posted by ianulimac on 2021-01-10 02:18:29

Tagged: , Reuse Motion , reuseaction.com , reuse , reclaim , upcycle , recycle , rock maple , floor , basketball court docket , strip flooring , table , conversion , maple , woodwork , craft , shop , woodshop , mortise , tenon , personalized , handmade , genuine , Buffalo , NY

#home furniture #Do it yourself #woodwork #woodworking #freedownload#woodworkingprojects #woodsmith ,wooden craft, wooden planer, good woodworking, wood chairs, wooden doing the job applications, well-liked woodworking, woodworking guides, woodworking workbench strategies

We harvest basketball courts from universities. Evidently every single 20-50 decades faculties switch 10s of 1000’s of square feet of gymnasium flooring and normally throw it absent. Admittedly it is a little bit of a pain to reuse in household configurations (but surely rather if the effort and hard work is put in) and appreciable quantities of this materials have been applied to make counters and tables desks and bar tops. For these buyers they needed a fitness center flooring desk and we found a unusual piece that however experienced its graphics. We observed a pair of outdated 1950s conference table legs and designed a desk all over the piece…like acquiring the graphics wrap around on the skirt.

The flooring is rock maple nailed into sleepers (effectively 2×3 ). I stapled 3/4 in plywood strips to the base prior to removing the sleepers. Following the sleepers ended up eradicated I set some minimal profile stiffeners created of extra parts of strip maple turned sideways. The apron was also made from excess items of maple. In this case I used the items with the graphics to generate the waterfall effect. Due to the fact the maple is tongue and groove I have to piece jointly parts on the groove side since they’d usually be backward. The corners had been created with a mortise and tenon joint. THe apron is brad nailed into the floor and blocks glued and stapled beneath around the edges,
The legs from the previous conference table were sanded primed and repainted with glossy white enamel paint. The leading and sides are sanded with 220 grit paper and coated with satin, drinking water-based mostly polyurethane. Treatment is taken to not get rid of the patina and anywhere cuts and sanding exposed new wooden..time and sun will ultimately even it out.

Posted by ianulimac on 2021-01-10 02:18:29

Tagged: , Reuse Action , reuseaction.com , reuse , reclaim , upcycle , recycle , rock maple , ground , basketball court docket , strip flooring , table , conversion , maple , woodwork , craft , store , woodshop , mortise , tenon , personalized , handmade , reliable , Buffalo , NY

#furniture #Do it yourself #woodwork #woodworking #freedownload#woodworkingprojects #woodsmith ,wood craft, wood planer, fantastic woodworking, picket chairs, wood working equipment, well-known woodworking, woodworking books, woodworking workbench plans

We harvest basketball courts from colleges. Seemingly each 20-50 a long time universities substitute 10s of thousands of sq. ft of gymnasium flooring and usually toss it away. Admittedly it is a little bit of a ache to reuse in residential settings (but unquestionably really if the effort is put in) and sizeable amounts of this material have been used to make counters and tables desks and bar tops. For these shoppers they preferred a gym ground table and we identified a uncommon piece that however had its graphics. We located a pair of outdated 1950s meeting table legs and designed a table around the piece…together with getting the graphics wrap all over on the skirt.

The flooring is rock maple nailed into sleepers (basically 2×3 ). I stapled 3/4 in plywood strips to the base prior to taking away the sleepers. Right after the sleepers had been taken off I put some minimal profile stiffeners produced of further parts of strip maple turned sideways. The apron was also manufactured from more parts of maple. In this case I employed the pieces with the graphics to build the waterfall result. Mainly because the maple is tongue and groove I have to piece jointly parts on the groove facet mainly because they’d or else be backward. The corners had been designed with a mortise and tenon joint. THe apron is brad nailed into the floor and blocks glued and stapled underneath around the edges,
The legs from the old meeting table had been sanded primed and repainted with glossy white enamel paint. The best and sides are sanded with 220 grit paper and coated with satin, drinking water-centered polyurethane. Treatment is taken to not remove the patina and where ever cuts and sanding exposed new wooden..time and solar will at some point even it out.

Posted by ianulimac on 2021-01-10 02:18:30

Tagged: , Reuse Motion , reuseaction.com , reuse , reclaim , upcycle , recycle , rock maple , floor , basketball court docket , strip flooring , desk , conversion , maple , woodwork , craft , store , woodshop , mortise , tenon , custom made , handmade , genuine , Buffalo , NY

#household furniture #Do it yourself #woodwork #woodworking #freedownload#woodworkingprojects #woodsmith ,wood craft, wooden planer, fantastic woodworking, wood chairs, wood functioning equipment, well known woodworking, woodworking textbooks, woodworking workbench programs