A person of my buddies desired to get into woodworking and I figured I could use an additional stool in the shop. This one is a little diverse in two techniques. The first is the measurement of the legs and the second is the dimensions of the little support bars in the legs.
To make this stool, it would expense upwards of $8 based on what variety of 2×4 you acquire, but I purchased some cull lumber and I utilised some scraps, so it price about $2.
Components
Commencing on the significantly left is a help bar for the legs. It is 1.5×1.5″ and 7″ long. To get these, just established the fence on the desk noticed to 1.5″ and rip two times, and boom. you will need to have 4 of these at 7 inches, so it may be a very good strategy to choose a 14 1/8″ 2×4 and rip that, then crosscut.
Next is the legs. They are 28″ prolonged with a line drawn 12″ up from the base. The peak of the legs is based on the peak of my wook bench. I’m a tad bit more than 6′ tall, so my perform bench is about 3′ off the ground. Anyway, you will require to make two dado cuts in every leg. I don’t have a dado blade so I just make multiple masses on the desk noticed. The dado cuts are produced on possibly aspect of the line at 12″ and are 1/2″ deep. When the assist bars go in, one pair will be earlier mentioned the 12″ line, and the other will be under it. It would not genuinely matter which pair goes wherever, just something to acquire into thought when reducing.
*NOT PICTURED*
I forgot about the small block at the prime that adds a Large amount of stability and holds issues in location. This will be four 2x4s lower to 6″.
Ultimately the prime. The top is very straightforward: two 12″ 2x4s and two 5″ 2x4s. Place them into a body condition so there is a 5×5″ hole in the center, and that is the prime. On the upcoming stool I make, I will in all probability take a router to it to curve off the edges, but that is just not necessary.
Assembly
The legs are the entertaining portion. The 7″ guidance bars go into the dado slots while the 6″ help bars (not pictured) will go at the leading, but still involving the legs. The reduce assist bars can either be attached with just glue and clamping if the dados are limited, or for a a lot quicker task, just a screw from the outside the house. The major supports I like to attach with a pocket-gap screw from the within. Kreg would make wonderful jigs for this, but for the life of me I are not able to figure out how to use it, so I just drilled a considerably even bigger hole and a pilot at a great sharp angle.
To connect the seat section, I utilised the similar pocket-hole method, coming up from the bottom.
Hope that helps if everyone is seeking for a shop stool. It will operate just like the 1 I posted yesterday, and will only be unique in which the bars go, and that’s just so they will not spin when I move on them. If you have any queries, put up a comment or PM me, I would be delighted to aid!
Posted by Raptor Fett GP on 2015-04-02 22:15:15
Tagged:
#furnishings #Diy #woodwork #woodworking #freedownload#woodworkingprojects #woodsmith ,wooden craft, wooden planer, fantastic woodworking, wooden chairs, wood functioning applications, preferred woodworking, woodworking guides, woodworking workbench programs