This board was mounted to the drill press to enable us finish the holes from the bottom. There are 2 different sized alternating holes, so there are 2 bushings of the proper dimension that thread onto the locator pin in the heart. This pin is centered on the chuck.
Posted by www.joeharmondesign.com on 2007-01-24 01:04:23
Tagged: , splinter , joe , harmon , joe harmon , picket , automobile , supercar , northstar , v8 , wood , woodworking , racecar , wheel , equipment , creating , venture , grad , faculty
#furniture #Diy #woodwork #woodworking #freedownload#woodworkingprojects #woodsmith ,wooden craft, wooden planer, fine woodworking, picket chairs, wood operating equipment, well-known woodworking, woodworking publications, woodworking workbench ideas